Introduction

PLEASE NOTE: This is a work in progress. If you notices any mistakes, please open an issue on github or contact me another way. Please check anything you order to verify correct quantities and correctness of the parts
The following pages will give a general guide for building the F16 ICP as shown in the image above. All files can be downloaded by cloning this repository on github, or by downloading the release

Depending on where you order all the parts, the cost can vary between 50 and 150 euros. (Assuming you already own the required tools)

This guide consist of the following chapters:

Navigation

1. Introduction
2. Bill Of Materials (BOM)
3. 3D printing
4. Finishing 3D prints
5. Electronics
6. Software
7. Assembly
8. Accessories